[OZAPRS] Fw: 40M APRS frequencies
Josh
vk2hff at vk2hff.ampr.org
Sun Dec 3 18:56:25 AEDT 2017
Thanks Gerard.
I had a minor issue with direwolf using the wrong tones earlier, it
appears that
the config line "MODEM 300" will cause 1600 & 1800 tones to be used but
"MODEM 300 # [comment]" causes 1200 & 1800 Hz tones.
After sorting that out I still didn't have any luck on either of the
frequencies, but my noise floor on 40m is S9+20 here today.
But I did manage to decode a couple of frames on 7047.17 a few minutes ago:
2017-12-03 18:10:58 VK4ALN-2 audio level = 52(18/15) [NONE] |||
[2.1] VK4ALN-2>VK2RX:(UA res, f=1)
2017-12-03 18:11:04 VK4ALN-2 audio level = 49(18/18) [NONE] |||
[2.1] VK4ALN-2>VK2RX:(UA res, f=1)
2017-12-03 18:11:05 VK4ALN-2 audio level = 50(17/16) [NONE] |||
[2.1] VK4ALN-2>VK2RX:(I cmd, n(s)=0, n(r)=0, p=0,
pid=0xf0)[KAM-XL-1.0-HM$]<0x0d>93056 BYTES AVAILAB
Increasing tx power didn't help, so will try from a better location when
I get a chance.
On 3/12/2017 4:37 PM, Gerard Hill wrote:
> Hi Josh,
>
> Checked the IGate log here and you're not in it yet. The path would be
> via ground wave so it would help to not be in an RF hole. NVIS
> propagation is limited at the moment.
> Beacon rate here is once per hour with two packets in the beacon.
>
> For testing on receive, tune to 7047.17 kHz where there are many beacons
> and a lot of packet activity from several stations in VK2 and one in
> VK4. My IGate operates there too.
>
> Graeme, the HF Gateway Table on the aprs.net.au
> <http://aprs.net.au/hf/hf-gateways/> site is out of date.
> The most current one is in the archive here
> <https://web.archive.org/web/20161029215543/http://aprs.net.au/hf/hf-gateways/>
> and it has the correct frequencies.
>
> Cheers,
> Gerard - VK2IO
>
> On 3 December 2017 at 15:44, Josh <vk2hff at vk2hff.ampr.org
> <mailto:vk2hff at vk2hff.ampr.org>> wrote:
>
> QF55ix, S/W Sydney. Roughly 40km SSW from VK2IO's 40m igate.
>
>
> On 3/12/2017 3:31 PM, Glen English VK1XX wrote:
> > where are you Josh?
> >
> >
> > On 3/12/2017 3:28 PM, Josh wrote:
> >> I briefly tried 40m APRS with my OT+ a few months ago but wasn't
> able to
> >> get through to any igates.
> >> I'm now running a Direwolf tracker in my car, so I've added a 300bps
> >> modem on 7048.6 LSB today.
> >> Currently I'm beaconing every 10 minutes with 50w but so far I
> haven't
> >> been igated and I haven't heard any frames either.
> >> I'm in a bit of a HF black hole here though, so might have to go
> for a
> >> drive to do a proper test.
> >>
> >> - Josh VK2HFF
> >>
> >>
> >>
> >> On 3/12/2017 12:24 PM, Scott Evans wrote:
> >>> That's why I'm on 40m too! 😉 the shift up in frequency was to align
> >>> with the WIA band plan. As I've mentioned on this many times, I'm
> >>> beaconing every 10 minutes with a maximum power output of 25w
> pep into a
> >>> Hustler 5-BTV
> >>>
> >>> That frequency is your dial frequency for using 1600/1800Hz tones,
> >>> however as I'm using a PK232MBX with DSP filter (after market
> addition
> >>> from Timewave) my dial frequency is 510hz higher at 7.049110 LSB to
> >>> compensate for the 2110/2310Hz tones of the PK232MBX!
> >>>
> >>> I'm using APRX with a 40m and a 2m ports, so anything heard on
> either is
> >>> forwarded directly to T2TAS.
> >>>
> >>>
> >>> On Sun., 3 Dec. 2017, 11:53 Graeme, <graeme at abrona.com.au
> <mailto:graeme at abrona.com.au>
> >>> <mailto:graeme at abrona.com.au <mailto:graeme at abrona.com.au>>> wrote:
> >>>
> >>> Â Â Â Â Thanks Scott for confirming the frequency listed in the gateway
> >>>     table. As my licence is only standard I don’t currently have
> >>> access
> >>> Â Â Â Â to 30m.
> >>> Â Â Â Â Â Â Â Â Â Graeme 2HFG
> >>> Â Â Â Â Â Â Â Â Â *From:* Scott Evans
> >>> Â Â Â Â *Sent:* Sunday, December 3, 2017 11:40 AM
> >>> Â Â Â Â *To:* Australian APRS Users
> >>> Â Â Â Â *Subject:* Re: [OZAPRS] Fw: 40M APRS frequencies
> >>> Â Â Â Â Â
> >>> Â Â Â Â Current frequency for 40m is 7.048600 LSB (1600/1800Hz) as
> far as
> >>> Â Â Â Â I'm aware there's only VK2IO & myself (VK7HSE) but it's
> possible
> >>> Â Â Â Â there's more but that's all that I'm aware of...
> >>>
> >>>
> >>> Â Â Â Â On Sun., 3 Dec. 2017, 10:42 Graeme, <graeme at abrona.com.au
> <mailto:graeme at abrona.com.au>> wrote:
> >>>
> >>>         Question now answered - I’ve been directed to the HF
> Gateway
> >>> Â Â Â Â Â Â Â Â table rather than the obsolete HF APRS frequency table
> on the
> >>> Â Â Â Â Â Â Â Â same site.
> >>> Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â *From:* Graeme
> >>> Â Â Â Â Â Â Â Â *Sent:* Sunday, December 3, 2017 10:03 AM
> >>> Â Â Â Â Â Â Â Â *To:* OZAPRS at aprs.net.au <mailto:OZAPRS at aprs.net.au>
> >>> Â Â Â Â Â Â Â Â *Subject:* 40M APRS frequencies
> >>> Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Is the HF frequency table shown on
> aprs.net.au <http://aprs.net.au>
> >>> Â Â Â Â Â Â Â Â <http://aprs.net.au>, particularly for the 40M band but
> also
> >>> the
> >>>         20M band, correct? 7036.00 appears to be outside the
> current
> >>> Â Â Â Â Â Â Â Â WIA band plan digital frequencies.
> >>> Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Thanks,
> >>> Â Â Â Â Â Â Â Â Graeme 2HFG
> >>> Â Â Â Â Â Â Â Â _______________________________________________
> >>> Â Â Â Â Â Â Â Â OZAPRS mailing list
> >>> Â Â Â Â Â Â Â Â OZAPRS at aprs.net.au <mailto:OZAPRS at aprs.net.au>
> >>> Â Â Â Â Â Â Â Â http://lists.aprs.net.au/mailman/listinfo/ozaprs
> <http://lists.aprs.net.au/mailman/listinfo/ozaprs>
> >>>
> >>> Â Â Â Â _______________________________________________
> >>> Â Â Â Â OZAPRS mailing list
> >>> Â Â Â Â OZAPRS at aprs.net.au <mailto:OZAPRS at aprs.net.au>
> <mailto:OZAPRS at aprs.net.au <mailto:OZAPRS at aprs.net.au>>
> >>> Â Â Â Â http://lists.aprs.net.au/mailman/listinfo/ozaprs
> <http://lists.aprs.net.au/mailman/listinfo/ozaprs>
> >>>
> >>> Â Â Â Â _______________________________________________
> >>> Â Â Â Â OZAPRS mailing list
> >>> Â Â Â Â OZAPRS at aprs.net.au <mailto:OZAPRS at aprs.net.au>
> <mailto:OZAPRS at aprs.net.au <mailto:OZAPRS at aprs.net.au>>
> >>> Â Â Â Â http://lists.aprs.net.au/mailman/listinfo/ozaprs
> <http://lists.aprs.net.au/mailman/listinfo/ozaprs>
> >>>
> >>>
> >>>
> >>> _______________________________________________
> >>> OZAPRS mailing list
> >>> OZAPRS at aprs.net.au <mailto:OZAPRS at aprs.net.au>
> >>> http://lists.aprs.net.au/mailman/listinfo/ozaprs
> <http://lists.aprs.net.au/mailman/listinfo/ozaprs>
> >>>
> >> _______________________________________________
> >> OZAPRS mailing list
> >> OZAPRS at aprs.net.au <mailto:OZAPRS at aprs.net.au>
> >> http://lists.aprs.net.au/mailman/listinfo/ozaprs
> <http://lists.aprs.net.au/mailman/listinfo/ozaprs>
> >
> >
> > _______________________________________________
> > OZAPRS mailing list
> > OZAPRS at aprs.net.au <mailto:OZAPRS at aprs.net.au>
> > http://lists.aprs.net.au/mailman/listinfo/ozaprs
> <http://lists.aprs.net.au/mailman/listinfo/ozaprs>
> _______________________________________________
> OZAPRS mailing list
> OZAPRS at aprs.net.au <mailto:OZAPRS at aprs.net.au>
> http://lists.aprs.net.au/mailman/listinfo/ozaprs
> <http://lists.aprs.net.au/mailman/listinfo/ozaprs>
>
>
>
>
> _______________________________________________
> OZAPRS mailing list
> OZAPRS at aprs.net.au
> http://lists.aprs.net.au/mailman/listinfo/ozaprs
>
More information about the OZAPRS
mailing list