[OZAPRS] Bad signal on 30m
Terry Neumann
tfn at rbe.net.au
Sun Nov 28 14:08:34 EST 2004
Richter, Mike W wrote:
Getting RF Feedback using a TinyTrak should not be a surprise - the
inputs and outputs go direct to the chip without ANY form of filtering -
I suggest putting a 1k resistor in series and a 0.01uF to ground on all
pins that run off the board.
Mike VK2BMM
_______________________________________________
ozaprs mailing list
ozaprs at marconi.ics.mq.edu.au
http://marconi.ics.mq.edu.au/cgi-bin/mailman/listinfo/ozaprs
G'day Mike and others,
This is good advice. I went even further as I thought (perhaps in the
wrong direction). I used minature rf chokes (from Jaycar) on all the
significant in/outputs from the board, and built mine TT3 board into a
diecast box as well.
This unit has been used in both of our vehicles on 30 metres and on 2
metres and appears to be free of RF issues - so far.
It may have been overkill, but I'm a farmer, and agricultural engineering
principles invariably find their way into all situations 8-)
Is there any merit in using rf chokes as opposed to using resistors, or
vice versa??
Regards,
Terry VK5ATN
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://second.aprs.net.au/pipermail/ozaprs/attachments/20041128/63d5bbb2/attachment.htm
-------------- next part --------------
An embedded and charset-unspecified text was scrubbed...
Name: ATT07066.txt
Url: http://second.aprs.net.au/pipermail/ozaprs/attachments/20041128/63d5bbb2/attachment.txt
More information about the Ozaprs
mailing list