[OZAPRS] 2.45 GHz Interference

[Damien Gardner Jnr]

I thought (apart from the speed) that the whole point of N was that it was on 5 Ghz, so you didn't have interference from 2.4ghz gear?  My dualband AP here runs A/N on 5, and B/G on 2.4.. ?

--DG

On 10/01/2011, at 10:12 PM, Darryl Smith wrote:

> People
>  
> Slightly off topic, but anyway. Wifi in my house has been really bad for ages. It just does not work. I thought it was interference from servers, but I replaced them, and things are still really bad. Well, today I needed to get some Perspex, and there was a cheap PC place a few doors down, so I picked up an 802.11n router for $55, that was supposed to have 5 times the range of 802.11g products.
>  
> After setting the device up, I tried to use my laptop in the Garage. No Wifi. Back to the office, and I found that it worked not too bad next to the access point, but it was marginal about 1.5m away.
>  
> I realized at this point that I probably had an interference issue. After all, what else could it be. Then I thought that it might be a faulty PIR on my alarm, since they are dual PIR/Microwave. Turning the alarm off resulted in fantastic Wifi performance. Turning it back on stopped the Wifi.
>  
> Then I went and found the manual for the PIR. Turns out that the units I purchased were not 10 GHz but 2.45 GHz.
>  
> Just something for people to watch out for. The units I have are from Crow Electronics
>  
> Darryl
>  
>  
> ---------
> Darryl Smith, VK2TDS POBox 169 Ingleburn NSW 2565 Australia
> Mobile Number 0412 929 634 [+61 4 12 929 634 Int] - 02 9618 6459
> www.radio-active.net.au/blog/ - www.radio-active.net.au/
>  
> _______________________________________________
> OZAPRS mailing list
> OZAPRS at aprs.net.au
> http://lists.aprs.net.au/mailman/listinfo/ozaprs

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.aprs.net.au/pipermail/ozaprs/attachments/20110110/e587123b/attachment.htm>