[OZAPRS] Nubie
Geoff
geoff-lists at gatwards.org
Sun Sep 20 11:15:58 EST 2009
Chris,
Take a look at http://www.aprs.net.au, under the relevant area that you are
operating in (HF or VHF).
The paths for each mode are listed there, but generally speaking, if you are
a FIXED station,
VHF = WIDE2-1
HF = GATE,WIDE2-1 (although if you are fixed station on HF you'd probably
need to re-think this - HF is usually only used by mobiles)
Beacon interval is also an important factor - if you are a FIXED station,
make sure you beacon no more than once every 20 minutes.
Regards,
Geoff VK2XJG
-----Original Message-----
From: ozaprs-bounces at aprs.net.au [mailto:ozaprs-bounces at aprs.net.au] On
Behalf Of Chris Herd
Sent: Sunday, September 20, 2009 10:20 AM
To: Australian APRS Users
Subject: [OZAPRS] Nubie
Hi Guys
I have a fixed APRS station and have loaded in a fixed position into the
system.
I have just connected a GPS to the system and want to know a few things
before I allow this system to beacon.
The system is Garmin GPS 60
TNC is a Kenwood RC-710.
RF is IC706.
Call sign is VK3TCH-5
So I want to know what settings to load into the kenwood to avoid over
beaconing my position and thus earning the wrath of the learned
gentlemen that keep the system working.
Any guidance gratefully recieved.
73
Chris Herd
VK3TCH/ZL2TCH
_______________________________________________
OZAPRS mailing list
OZAPRS at aprs.net.au
http://lists.aprs.net.au/mailman/listinfo/ozaprs
More information about the OZAPRS
mailing list