[OZAPRS] TT3 works on HF but not on VHF
Peter Dodd
dodd.pc at bigpond.com
Sat Apr 25 18:10:12 EST 2009
Hi,
Can you decode your transmitted packets with another receiver and whatever
software you have for that purpose eg agw packet engine etc.
Regards
Peter VK7KPC
----- Original Message -----
From: "David and Justine Olsen" <davejust at bigpond.net.au>
To: "Australian APRS Users" <ozaprs at aprs.net.au>
Sent: Saturday, April 25, 2009 5:40 PM
Subject: [OZAPRS] TT3 works on HF but not on VHF
>I got my replacement TT3 which now shows a valid GPS light, and I tested
>it on 40m and it worked fine. I then reconfigured it for VHF and tested it
>on my mobile antenna but no success. It transmits fine and I receive it on
>my base.
> Thinking my mobile which is very immobile at present (repairs) had a
> dicky antenna or was located in a bad spot, I then set up the same radio
> and TT# on my 2 meter J beam which I normally use to access the repeater-
> still no luck.
>
> The TT3 is configured.
>
> Callsign VK4MDX-9
> Digi Path WIDE1-1, WIDE2-1
> SYMBOL J
> TABLE OVERLAY /
> Auto TX delay 300
> Auto Tx Rate 120
> Manual Tx Delay 133
> Quiet Time 526
> Calibration 128
> Nothing else enabled.
>
> The TT3 is connected to GPS and show valid GPS and transmits- confirmed
> receive signal on my Kenwood 2m rig.
> My radio is an Icom706MkIIG
> The TT3 triggers transmit via the mic socket
> The rig dial is set to 145.175 MHz
>
> Why is my signal not decoded and not appear on the internet?
>
> David
>
> VK4MDX
>
>
>
> _______________________________________________
> Ozaprs mailing list
> Ozaprs at aprs.net.au
> http://aprs.net.au/mailman/listinfo/ozaprs
_______________________________________________
Ozaprs mailing list
Ozaprs at aprs.net.au
http://aprs.net.au/mailman/listinfo/ozaprs
More information about the Ozaprs
mailing list