[OZAPRS] TT3 works on HF but not on VHF
David and Justine Olsen
davejust at bigpond.net.au
Sat Apr 25 17:40:42 EST 2009
I got my replacement TT3 which now shows a valid GPS light, and I
tested it on 40m and it worked fine. I then reconfigured it for VHF
and tested it on my mobile antenna but no success. It transmits fine
and I receive it on my base.
Thinking my mobile which is very immobile at present (repairs) had a
dicky antenna or was located in a bad spot, I then set up the same
radio and TT# on my 2 meter J beam which I normally use to access the
repeater- still no luck.
The TT3 is configured.
Callsign VK4MDX-9
Digi Path WIDE1-1, WIDE2-1
SYMBOL J
TABLE OVERLAY /
Auto TX delay 300
Auto Tx Rate 120
Manual Tx Delay 133
Quiet Time 526
Calibration 128
Nothing else enabled.
The TT3 is connected to GPS and show valid GPS and transmits-
confirmed receive signal on my Kenwood 2m rig.
My radio is an Icom706MkIIG
The TT3 triggers transmit via the mic socket
The rig dial is set to 145.175 MHz
Why is my signal not decoded and not appear on the internet?
David
VK4MDX
_______________________________________________
Ozaprs mailing list
Ozaprs at aprs.net.au
http://aprs.net.au/mailman/listinfo/ozaprs
More information about the Ozaprs
mailing list