[OZAPRS] TinyTrack3 Plus GPS Combo- Problems

[David and Justine Olsen]

Yes the solder pads are as should be

David


On 14 Apr 2009, at 07:26, Ray Wells wrote:

> I always got same day (email) replies from Byonics. Their customer  
> care is second to none.
>
> Just a thought. I know it "should" already be done but have you  
> checked to see if the solder pads on the PCB are bridged to supply  
> 5v to the DB9. There are options to supply 5 or 12 volts by  
> bridging the correct two solder pads.
>
> Ray vk2tv
>
> David and Justine Olsen wrote:
>> Thanks for your help.
>>
>> What annoys me is I ordered a completed kit to avoid all of this
>> I know- tell Byonics- I did...still no time to get this working  
>> and 6 days further delay etc etc
>>
>>
>> David
>>
>>
>> On 13 Apr 2009, at 19:54, Mark Cheeseman wrote:
>>
>>> David and Justine Olsen wrote:
>>>> Well. No 5 V anywhere- not on pin 4 or any pins
>>>
>>> That looks like your problem then. Trace it back to J7 on the TT3  
>>> board - there must be a problem somewhere around there, since you  
>>> obviously have +5V power as the LEDS are doing their power-up dance.
>>>
>>> -Mark
>>>
>>> _______________________________________________
>>> Ozaprs mailing list
>>> Ozaprs at aprs.net.au
>>> http://aprs.net.au/mailman/listinfo/ozaprs
>>
>> _______________________________________________
>> Ozaprs mailing list
>> Ozaprs at aprs.net.au
>> http://aprs.net.au/mailman/listinfo/ozaprs
>>
>
> _______________________________________________
> Ozaprs mailing list
> Ozaprs at aprs.net.au
> http://aprs.net.au/mailman/listinfo/ozaprs

_______________________________________________
Ozaprs mailing list
Ozaprs at aprs.net.au
http://aprs.net.au/mailman/listinfo/ozaprs