<div dir="ltr">Bob and others, (apologies for the thread hi-jack from HF-APRS)<div><br></div><div>What type of batteries are you using with the TT-AIO?</div><div><br></div><div>I haven't been having much success with mine and I am thinking perhaps its because the voltage on using 8 Ni-Mh batteries is too low?</div>
<div><br></div><div>Cheers,</div><div><br></div><div>Matt</div><div>VK2ADF</div></div><div class="gmail_extra"><br><br><div class="gmail_quote">On Wed, Feb 26, 2014 at 5:22 PM, VK5FO <span dir="ltr"><<a href="mailto:aprs@pilbara.com.au" target="_blank">aprs@pilbara.com.au</a>></span> wrote:<br>
<blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><br>
Ray,<br>
<br>
The whole reason I got into APRS was for tracking of me when I was out<br>
paddling!<br>
<br>
<br>
I use 2 different trackers when out in the Kayak - a TT-AIO and my VX8-R.<br>
The TT-AIO is a 10W tracker and the VX8-R is 5W.<br>
<br>
<br>
With the TT-AIO, I simply add a line to it to secure it to the boat and<br>
push it under bungee's on the deck.  With 8 AA batteries in this tracker,<br>
running a 2 minute beacon, It lasts around 16 days of continual use<br>
between charges (Yes, I forgot to turn it off and had it working for that<br>
long).  It is truly a case of set and forget with the TT-AIO, whereas the<br>
VX8-R on the big battery, It only lasts me about 10 hours between<br>
charging/swapping Batteries.<br>
<br>
It is a nice sealed waterproof box and all I need to do is to make sure<br>
the seal is clean before closing.  In 4 years, never had a problem with<br>
water ingress with it affixed to the deck.<br>
<br>
My VX8, I just put into a pocket and tie it to my PFD, speaker mic with<br>
the GPS in it on my shoulder.  More than once the speaker mic has fallen<br>
off into the water and I have thoroughly tested the IPX7 waterproof<br>
capabilities.<br>
<br>
I have done in excess of 5,000km of paddling, both training and several<br>
Marathons over the last 4 years and I have found that they both work well.<br>
<br>
Yep, when paddling in a Marathon, it is good to know my Support crew can<br>
keep tabs on my progress and have everything ready (hot food, drinks etc)<br>
when I stop!<br>
<br>
These days, I tend to use the VX8, and make use of 6M to talk back to my<br>
land crew.<br>
<br>
Both of these are off the shelf solutions and have worked well for me.<br>
<br>
Matt's solution is of course very lightweight and seems to work pretty<br>
well - Yep, paddled past said tracker on the back of Kayaks a few times<br>
now :)<br>
<br>
<br>
Cheers,<br>
Bob<br>
VK5FO<br>
<br>
<br>
> ---------------------------- Original Message ----------------------------<br>
> Subject: Re: [OZAPRS] HF APRS<br>
> From:    "Ray Wells" <<a href="mailto:vk2tv@exemail.com.au">vk2tv@exemail.com.au</a>><br>
> Date:    Wed, February 26, 2014 16:13<br>
> To:      <a href="mailto:ozaprs@aprs.net.au">ozaprs@aprs.net.au</a><br>
> --------------------------------------------------------------------------<br>
<div class="im HOEnZb">><br>
> Mathew,<br>
><br>
> Thanks for the info. It's always good to know how others went about an<br>
> installation.<br>
><br>
> I had considered some sort of waterproof container, ranging from<br>
> Tupperware to some round 4l (approximately) buckets with tight-fitting<br>
> lid that I have here. That sort of arrangement could house the radio<br>
> (probably use my Baofeng 5W H/H), the TT3+ tracker (+battery) and puck<br>
> style GPS and it would all fit under the front hatch of the Hobie. The<br>
> Hobie has a mast socket (for a sail) close to the hatch and I'd thought<br>
> of using a 1m long aluminium mast of appropriate diameter to support a<br>
> GPI antenna. A w/proof box mounted on the mast for the gear would<br>
> facilitate quick installation/removal. There's probably other options<br>
> I've not thought about yet.<br>
><br>
> Please send the images.<br>
><br>
> Ray vk2tv<br>
><br>
><br>
</div><div class="HOEnZb"><div class="h5">> On 26/02/14 11:31, Matthew Cook wrote:<br>
>> Ray,<br>
>><br>
>> I've built a couple of APRS trackers for use in kayak's.<br>
>><br>
>> At the local Foodland (supermarket) I found some plastic food storage<br>
>> containers "Systema" brand that are water tight and about the right<br>
>> size to hold my tracker.  I soldered a RG174 SMA connector to a brass<br>
>> washer and attached some ground radials.  This was simply mounted<br>
>> through the lid of the box and hot melt glued into position.  One of<br>
>> the Comet dual band HT antennas completed the setup.  The tracker was<br>
>> a repurposed HAB payload which outputs 100mW.   The whole thing runs<br>
>> off a pair of AA batteries for 30 odd hours.  Can send pictures if<br>
>> youre interested.   So far the tracker has done just over 400kms in<br>
>> various kayak marathons.   It makes it very easy for ones "land crew"<br>
>> to track their paddlers progress.<br>
>><br>
>> I'm just in the process of doing the same thing again for my Trailer<br>
>> Sailer.  I found a 2m marine antenna from the states at a reasonable<br>
>> cost.  Looks like a VHF156MHZ marine antenna just a little longer.<br>
>> That will run from the boat giving me telemetry (battery volts and<br>
>> position) while I'm not there.  I'm using a slightly larger food<br>
>> storage container (1L) to give the unit a bit more resilience to salt<br>
>> ingress etc.<br>
>><br>
>> YMMV<br>
>><br>
>> 73's<br>
>><br>
>> Matthew<br>
>> VK5ZM<br>
><br>
</div></div><div class="HOEnZb"><div class="h5">> _______________________________________________<br>
> OZAPRS mailing list<br>
> <a href="mailto:OZAPRS@aprs.net.au">OZAPRS@aprs.net.au</a><br>
> <a href="http://lists.aprs.net.au/mailman/listinfo/ozaprs" target="_blank">http://lists.aprs.net.au/mailman/listinfo/ozaprs</a><br>
><br>
><br>
><br>
><br>
><br>
<br>
<br>
_______________________________________________<br>
OZAPRS mailing list<br>
<a href="mailto:OZAPRS@aprs.net.au">OZAPRS@aprs.net.au</a><br>
<a href="http://lists.aprs.net.au/mailman/listinfo/ozaprs" target="_blank">http://lists.aprs.net.au/mailman/listinfo/ozaprs</a><br>
</div></div></blockquote></div><br></div>