[OZAPRS] TT3 works on HF but not on VHF

Ray Wells vk2tv at exemail.com.au
Sun Apr 26 08:42:19 EST 2009


David,

Have you successfully used the particular radio with a TNC or another 
modem - baycom, soundmodem, etc? Just trying to narrow down the number 
of possibilities.

Ray vk2tv


David and Justine Olsen wrote:
> I got my replacement TT3 which now shows a valid GPS light, and I 
> tested it on 40m and it worked fine. I then reconfigured it for VHF 
> and tested it on my mobile antenna but no success. It transmits fine 
> and I receive it on my base.
> Thinking my mobile which is very immobile at present (repairs) had a 
> dicky antenna or was located in a bad spot, I then set up the same 
> radio and TT# on my 2 meter J beam which I normally use to access the 
> repeater- still no luck.
>
> The TT3 is configured.
>
> Callsign VK4MDX-9
> Digi Path WIDE1-1, WIDE2-1
> SYMBOL J
> TABLE OVERLAY /
> Auto TX delay 300
> Auto Tx Rate 120
> Manual Tx Delay 133
> Quiet Time 526
> Calibration 128
> Nothing else enabled.
>
> The TT3 is connected to GPS and show valid GPS and transmits- 
> confirmed receive signal on my Kenwood 2m rig.
> My radio is an Icom706MkIIG
> The TT3 triggers transmit via the mic socket
> The rig dial is set to 145.175 MHz
>
> Why is my signal not decoded and not appear on the internet?
>
> David
>
> VK4MDX
>
>
>
> _______________________________________________
> Ozaprs mailing list
> Ozaprs at aprs.net.au
> http://aprs.net.au/mailman/listinfo/ozaprs
>

_______________________________________________
Ozaprs mailing list
Ozaprs at aprs.net.au
http://aprs.net.au/mailman/listinfo/ozaprs



More information about the Ozaprs mailing list